BEST ACCESS SYSTEMS 35HW Instrukcja Obsługi Pobierz pdf (Strona 136)

Service and Maintenance for Cylindrical Locks

5–26 W Series Service Manual

REPLACING COMPONENTS FOR CYLINDRICAL LOCKS

Removing and

reinstalling the

solenoid

Because of the complex nature of this procedure, BEST recommends

that you order a new cylindrical chassis. Contact your BEST

representative.

Use the part numbers listed in Reversing the solenoid when changing

the function when ordering a new cylindrical chassis.

Removing and

reinstalling the

RQE rose liner for

cylindrical locks

Removing the RQE rose liner

1. For IDH Max Locks

■ Remove the access door. See Task C. To remove the access door:

on page 5–4.

■ Remove the inside lever/knob. See Task B1. To remove the keyed

lever/knob: on page 5–3.

■ Remove the upper and lower escutcheon screws from the inside

escutcheon.

■ Remove the inside hub washers.

Note: You can let the inside escutcheon dangle from the field wire

harness while completing this task.

For electrified locks

■ Remove the inside lever/knob. See Task B2. To remove the plain

lever/knob: on page 5–4.

■ Insert the solid, curved end of the spanner wrench in between

the inside rose and the sleeve, as shown in Figure 5.25. Pry the

rose until it pops off the liner.

2. Disconnect the RQE connector.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 227 228

Brak uwag

BEST ACCESS SYSTEMS 35HW Instrukcja Obsługi Strona 136