BEST ACCESS SYSTEMS 35HW Instrukcja Obsługi Pobierz pdf (Strona 143)

Additional Service and Maintenance for IDH Max Locks

W Series Service Manual 6–3

Reinstalling the sensor and solenoid wire harness

1. Connect the sensor and solenoid wire harness to the control

electronics circuit board.

2. Make the connections and reinstall the inside escutcheon. For

mortise instructions, see Task F. To secure the escutcheons and

complete the connections: on page 4–20. For cylindrical

instructions, see Task G. To secure the escutcheons and complete

the connections: on page 5–15.

3. Reinstall the inside lever/knob. For mortise instructions,

see Task G. To reinstall the inside and outside levers/knobs: on

page 4–21. For cylindrical instructions, see Task H. To reinstall the

inside and outside levers/knobs: on page 5–16.

4. Reinstall the core and throw member. For mortise instructions, see

Task H. To reinstall the core (EEL and EEU only): on page 4–23.

For cylindrical instructions, see Task I. To reinstall the core and

throw member: on page 5–17.

5. Making sure that the access door does not pinch any wires, insert

the tabs of the access door into its mating slots and swing the door

closed. Use the appropriate bit driver to secure the access door with

the security screw. Tighten firmly.

Removing and

reinstalling the

reader wire harness

Removing the reader wire harness

To replace a reader wire harness for the magnetic stripe swipe or

proximity card reader, a new outside escutcheon gasket (A60725) is

needed.

1. Remove the core and throw member. For mortise instructions, see

Task A. To remove the core: on page 4–3. For cylindrical

instructions, see Task A. To remove the core and throw member:

on page 5–3.

2. Remove the inside lever/knob. For mortise instructions,

see Task B. To remove the inside and outside levers/knobs: on

page 4–4. For cylindrical instructions, see Task B2. To remove the

plain lever/knob: on page 5–4.

3. Use the appropriate bit driver to remove the security screw from the

access door. Open the access door and remove it from the inside

escutcheon.

4. Remove the outside escutcheon from the door. For mortise

instructions, see Task D. To disconnect the connections and

remove the outside escutcheon: on page 4–6. For cylindrical

instructions, see Task D. To disconnect the connections and

remove the outside escutcheon: on page 5–4.

5. For magnetic stripe swipe or proximity card readers, remove the

escutcheon gasket from the outside escutcheon and discard the

gasket.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 227 228

Komentarze do niniejszej Instrukcji

Brak uwag

BEST ACCESS SYSTEMS 35HW Instrukcja Obsługi Strona 143

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kontrolery drzwi antywłamaniowych BEST ACCESS SYSTEMS 35HW