BEST ACCESS SYSTEMS 35HW Instrukcja Obsługi Pobierz pdf (Strona 153)

Additional Service and Maintenance for IDH Max Locks

W Series Service Manual 6–13

Removing and

reinstalling the

magnetic stripe

insertion card

reader

Removing the magnetic stripe insertion card reader

1. Remove the core and throw member. For mortise instructions, see

Task A. To remove the core: on page 4–3. For cylindrical

instructions, see Task A. To remove the core and throw member:

on page 5–3.

2. Remove the inside and outside knobs/levers. For mortise

instructions, see Task B. To remove the inside and outside

levers/knobs: on page 4–4. For cylindrical instructions,

see Task B1. To remove the keyed lever/knob: on page 5–3.

3. Use the appropriate bit driver to remove the security screw from the

access door. Open the access door and remove it from the inside

escutcheon.

4. Remove the outside escutcheon. For mortise instructions, see Task

D. To disconnect the connections and remove the outside

escutcheon: on page 4–6. For cylindrical instructions, see Task D.

To disconnect the connections and remove the outside escutcheon:

on page 5–4.

5. Unscrew the two reader electronics screws on the card reader and

remove the harness clamp. Save the harness clamp and screws.

6. Disconnect the reader wire harness from the circuit board on the

card reader.

7. Remove the card reader.

Figure 6.5 Removing and reinstalling the magnetic stripe swipe card reader

Reader harness

Magnetic stripe

swipe card

reader assembly

Outside escutcheon

Slot

Reader gasket

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 227 228

Brak uwag

BEST ACCESS SYSTEMS 35HW Instrukcja Obsługi Strona 153