BEST ACCESS SYSTEMS 35HW Instrukcja Obsługi Pobierz pdf (Strona 185)

Installation Instructions for 34HW–35HW IDH Max Mortise Locks

BEST ACCESS SYSTEMS

Indianapolis, Indiana

Installation Instructions for 34HW–35HW IDH Max Mortise Locks

Installing the panel interface module

24 Set panel interface module DIP

switches

Set the DIP switches on the panel interface circuit

board. Refer to the table below. Default settings are

shown in boldface.

25 Set and connect power supply

1 Make sure that the output voltage of the power supply

for the panel interface module and lock is set to

15 volts DC or lower.

2 Make the final power supply connections.

3 Adjust the power supply output voltage to

13.8 volts DC.

Feature Option DIP Switch Setting

Reader LED input configuration

Provides the ability to select between one-wire and two-wire LED

operation for the reader LED input.

Two-wire operation Switch 1–ON

One-wire operation Switch 1–OFF

Baud rate selection

Provides the ability to select the baud rate for communication between the

panel interface circuit board and the lock’s control electronics circuit board.

Note: To control the baud rate using DIP switches 2 and 3 on the panel

interface circuit board, DIP switches 6 and 7 on the control electronics circuit

board both must be set to ON (automatic baud rate detection).

38400 bps Switch 2–OFF Switch 3–OFF

19200 bps Switch 2–ON Switch 3–OFF

9600 bps Switch 2–OFF Switch 3–ON

2400 bps Switch 2–ON Switch 3–ON

Request-to-exit (RQE) status output configuration

Provides the ability to invert the request-to-exit (RQE) status signal. If DIP

switch 4 is ON, the contact is closed when the door knob/lever is turned,

activating the RQE switch.

Normally-open (NO) Switch 4–ON

Normally-closed (NC) Switch 4–OFF

Door status & latchbolt status / Door status output configuration

Provides the ability to invert the signal for this output. If DIP switch 8 is ON

and DIP switch 5 is ON, the contact is closed when the door is secure (the

door status switch & latchbolt status switch are closed). If DIP switch 8 is

OFF and DIP switch 5 is ON, the contact is closed when the door is

unsecured (the door status switch is closed).

Normally-closed (NC) Switch 5–ON

Normally-open (NO) Switch 5–OFF

Communication tamper / Latchbolt status output configuration

Provides the ability to invert the signal for this output. If DIP switch 8 is ON

and DIP switch 6 is ON, the contact is closed when the communication

connection between the panel interface circuit board and the lock’s control

electronics circuit board is OK. If DIP switch 8 is OFF and DIP switch 6 is ON,

the contact is closed when the latchbolt is extended (the latchbolt status

switch is closed).

Normally-closed (NC) Switch 6–ON

Normally-open (NO) Switch 6–OFF

Figure 23 Setting DIP switches

Set DIP

switches.

continued

Setting DIP switches

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 227 228

Komentarze do niniejszej Instrukcji

Brak uwag

BEST ACCESS SYSTEMS 35HW Instrukcja Obsługi Strona 185

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kontrolery drzwi antywłamaniowych BEST ACCESS SYSTEMS 35HW